Friday, January 4, 2013

How you can Replace a PSP Laser

Laser within your PSP may be the most important part since it reads the game discs and permits them to become played on the device. So if the laser inside your PSP is damaged or broken, your PSP will be fully worthless. However, you are able to repair the issue by your self. You can effortlessly open your PSP cover and replace the damaged laser. And also you need to have to completely disassemble your PSP to access the laser.


Factors You require

Small Phillips-head screwdriver

Guidelines

1. Energy off your PSP. Turn it over and take off the battery cover. Get the battery out of its compartment.

2. Take away the 4 screws from every corner of the battery compartment using the Phillips-head screwdriver. Very first to take away the 2 screws positioned on the leading and bottom from the corners of the side in the unit. Then get rid of the one on the bottom on the unit.

3. Use your fingers or the plastic tool to pry the faceplate off the unit and set it aside.

4. Insert the tip of your Phillips-head screwdriver inside the seam amongst the button bar and bottom in the LCD screen. Then, gently pry the button bar off the unit.

5. Use the tip of your screwdriver to pop the 4 tabs on each and every corner in the LCD screen, and then lift the screen up. Very carefully take off the 2 screen cables from the back on the screen and set the screen aside.

6. There is a metal LCD plate covering the motherboard and you require to get rid of all 7 screws from it. Take away the LCD plate and set it aside.

7. Gently unplug the 2 big orange ribbon cables from the left side in the motherboard. Get rid of all screws in the sides on the motherboard together with your screwdriver.

8. Lift the motherboard out in the unit and disconnect the white antenna wire in the corner from the board. Place the motherboard away.

9. Get rid of all screws from the metal motherboard assistance plate underneath exactly where the motherboard employed to sit, and after that remove the plate itself.

10. Take away all screws in the sides of the memory stick circuit board and lift it out in the unit to expose the laser assembly door.

11. Pop the door up and reveal the metal laser assembly with all the screwdriver's tip.

12. You will find 4 screws on every corner on the square metal assembly. Use your screwdriver to eliminate them then lift the square metal assembly out from the unit.

13. Eliminate all screws in the sides from the assembly and gently pull it apart.

14. Now you'll be able to get rid of the old broken assembly and replace with all the new one. At last, reassemble your PSP within the reverse order you took it apart.

No comments:

Post a Comment